Jump to content

Recommended Posts

With all display issues I make sure the firmware on the PLC is up to date, then download a BLANK project, re-initialize, then download my working project. If you still have a problem, you will need to contact your distributor or Unitronics for any other available remedy.

Link to post
Share on other sites

Reset means re-boot and is equivalent to a power cycle. Re-initialize means reset plus erase all memory operands. Either can be performed from the PLC INFO Mode or from the VisiLogic Connection menu item. It's usually a good idea to re-initialize prior to (or immediately after) downloading a new program for the first time.

Link to post
Share on other sites

Hi

 Please try to recover this issue as follow:

·         Download a blank project to your PLC by using COM port RS232 115200 baud rate.

·         Initialize and reset the PLC (all value will be cleared)

·         Open the original project

·         Restore system images (see below how to..)

·         Perform build-all from Build menu

·         Download all & burn the project to the PLC (again by using COM port RS232 115200 baud rate)

 image.png 

I hope it helps.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...