Jump to content

Recommended Posts

I asked a similar question ages ago when I was stripping threads out with minimal force. 

All the answers are here:

http://forum.unitronics.com/topic/3586-terminal-blocks-issuesproblems/?tab=comments#comment-13139

As usual with Pheonix, the myriad they have makes it hard to find the exact match.  I've always gone on 5mm pitch and this one:

MSTB 2,5/10-ST - 1754601

I gave up trying to find a connector that exactly matched the 17.3mm on the originals of what Pheonix call Length.  Someone else may have.

The 5mm pitch as against 5.08 can be a PITA at times.  I have a number of different gizmos that look to use the same plug, but closer inspection with verniers shows they aren't.

cheers, Aus

  • Like 1
Link to post
Share on other sites

Further to this, Simon alerted me to what he uses, which is here:

https://www.dinkle.com/en/terminal/5ESDV-XXP

He also mentioned very fine print incorporated into the moulding on the ends.  On some of my originals I have actually have "-5.0 2EDGK DEGSON" imprinted onto them.  So perhaps the Phoenix usage is not completely correct.  I think it's clearly a case of if something is rated ok, matches pitch and style and suits your use, then it will do the job!

Thanks Simon for the input.

cheers, Aus

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...