Display problems with Remote Access

[John_R 14]

alright Fellas, riddle me this..........

I have a V570 out in my workshop, one of its duties is control of the heaters in two different rooms.
On the Heat Control display I have a couple of indicators (binary images linked to outputs) that turn green when the output to the heater relay is on.

Which works as it should when in debug from Vision (and on the V570 itself);

 

But when I go to Remote Access to look at the same display (from the same PC), my indicators do not work;

 

I first thought it was because I had an older version of Remote Access install, so I replaced it with the newest version, same results.

Anyone have any ideas why it does this?

JohnR

[Joe Tauser 361]

You have to tell Remote Access to upload the PLC's images and create a local use file-

 

Joe T.

[John_R 14]

Well, once again Joe, you are correct

But the bizarre thing  is that in all my years using Remote Access "back at the plant", I've never had to do that???

JohnR ⛄