Jump to content

IO Comm error on power up USP-104-B10 and email issue


Recommended Posts

I am getting a "Uni-I/O Communication Error" when I power up this USP-104-B10 as shown in the picture. I have it connected to our network via ethernet and I can ping its IP as well as go online with it. So I find this message curious. 

In addition, when I try to email from this PLC, I get a -1 error code which is described in the help (I RTFM every once in awhile) as a "General COM Error. Please check the physical connections".  I have had this email working in the past and I am using the same settings. FYI - don't use a free gmail account. 

Any ideas?

Thanks,

Norm

1414554509_IOCommerror.thumb.jpg.4dd20efe1ada0857cf9eb7ed748f3e1e.jpg

 

Link to comment
Share on other sites

If the PLC program has I/O modules set up in the hardware configuration and you don't have those modules connected, this is normal. Just close the message and proceed as you wish. If you don't want the message to appear, either connect the module(s) or change the program to remove the I/O modules.

Link to comment
Share on other sites

  • 3 weeks later...

1. Make sure the IO unit has it's own power connections for 24+ and 0v and they are in the correct locations

2. You can try to power off then disconnect and reconnect the IO unit from the bus, then reboot.

3. Update the IO unit firmware through UNI-Apps.

I run into this quite a bit, usually it's #3

-Swervo

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...