Hi Aus,
I send you some screnshoots.
We tryed to solve the problem with the net 18.
Now the start command works, the start message comes back, but the end message comes sometimes back (not always)
Best regards
Pal
I have V130 with an Enfora GSM 1308 modem.
Appliance is a remote controlled air sampler
The measurement must start by SMS - it works,
Applliace send back a SMS: Measurement started - it works as well.
End of the measuring time (10 minits) should send an SMS : measuring finished - but in this case often comes in an error: Send fail bitmap
Sometimes the 3 steps cycle works properly, sometimes the third step failed.
What du you advise?