[Unitronics V350_J-R34]

31 minutes ago, sgull said:

I think you have the choice of 2 digital outputs from the IFM unit or 1 digital and 1 analog.

You need to decide how you are going to control.

You can use two digital and use the sensor settings to control levels or use the 4-20ma to give you a level and program the PLC to switch at specific levels.

If you use the analog you need to use an analog input on the PLC.

So the Digital outputs from the ifm sensor would run to the inputs on the PLC correct?

[Unitronics V350_J-R34]

Thanks Joe, Is there a Specfic output for the 4-20ma or do you plug into a pnp output and program from there?

[Unitronics V350_J-R34]

all we are doing is when the level gets too high it opens a valve and drains until it gets lower and closes the valve...          

[Unitronics V350_J-R34]

I'll start with that...       

Thanks...             

[Unitronics V350_J-R34]

I am looking for some help wiring a laser sensor into this PLC . Its a IFM O1D100...

[V350-J-R34 Analog input help...]

I'm in need of some help wiring a IFM O1D100 To a unitronics V350-J-R34. Any Ideas??