[Jazz JZ20-J-T20HS + Steppermotor Advice needed.]

Goodday Joe and DanT, 

Thanks for the help in the comments above. I figured it out with the help  and the wiring of MattB. The machine makes the right steps and works really well combined with some other sensors.  Sorry for the late reaction. 

Greetings,

Wills.

 

[Jazz JZ20-J-T20HS + Steppermotor Advice needed.]

Hi Dant,

Tommorow i will create a schematic.

Thanks,

Wills

[Jazz JZ20-J-T20HS + Steppermotor Advice needed.]

Hi Dant,

Thank you for your reply.  Below you will find the datasheet of the tb6600 driver

If i am right i can only wire from the plc with a resistor in between. The plc will give 24 v if i am right and the possible voltage for the driver in the dir and pul section is 5 volts.

https://www.mcielectronics.cl/website_MCI/static/documents/TB6600_data_sheet.pdf

Greetings,

WIlls

[Jazz JZ20-J-T20HS + Steppermotor Advice needed.]

Goodmorning Everyone,

I have recently started a project controlling a steppermotor with a Jazz JZ20-J-T20HS PLC. 

I got the idea from a youtube video that i recently came by.  In the video they control a Steppermotor with a plc and a drive controller for the steppermotor.

I know how to program the code in my plc u90 program but got a hard time figuring out the right "stepper motor drive controller". Is anyone known by this technic that can recommend a drive controller that i can put togheter with my jazz.  Preferably a controller with a clear wiring diagram.  I do have a "TB6600 Stepper Motor drive", availeble but i can't figure out how to wire this drive.

The idea is to create a movement in which i can set the position and speed of the steppermotor. 

Below you find the link of the drive i have available right now:

https://www.kiwi-electronics.nl/nl/tb6600-stepper-motor-driver-3752

Below you will find the link of the video i found online:

Thank you very for the time,

Wills