I have been able to get my project working somewhat and I have attached the latest ladder. With this setup I am able to get the counters to increment but it seems I am only getting about 10 percent of the pulses to register, With a ppr of 13 and rpm of 6000 I should be seeing 1300 pulses per second. If I spin the shaft by hand i do indeed get the exact amount of pulses I would expect. I have a gear bow with a 12.7:1 ratio . 1 revolution by hand at the driven end gives me 166 pulses. 13 ppr x 12.7 ratio = 166 pulses per rev
If anyone has info regarding how to set up the high speed inputs this may be where I am messing up
It seems like I may only be getting counts based upon the scan rate and not the HSC I am trying to use.
Any though would be greatly appreciated,
Chair lift project.ulpr