kinto11

i have my high-speed output setup to vary frequency and provide pulses but i need to figure out how to use a timer to slow down the pulses and speed them up when i provide a set point.

i looked my post over after i wrote it and i did not provide enough information I'm sorry, I'm trying to control the increase and decrease of frequency to help protect the motor when you turn it on and so it does not miss pulses when it starts up. I'm using a 23L104S-LW8 stepper motor and a MBC25081TB driver, the plc I'm using is a unitronics V200-18-E6B I/O module

Hello, I have never used a forum before so I apologise if it's wrong for me to ask a question on my first post but iv been working on a stepper motor project and I'm trying to figure out how to control the increase and decrease of the speed during transitions. I'm honestly at a loss IV looked online but I haven't been able to make any head way as of yet.