[Start up parameters]

Do you mean in SB2? I can set it to "set" or "reset" 

Thank you

[Start up parameters]

When PLC starts I need it to clear all previous settings/bit values. I tried     |----(SB2)---(SB24)---- all that did was put it in a constant reboot situation. Thank you in advance for helping me with these greenhorn questions.

[Slow down rate]

Hi, I am trying to read a 4-20ma level sensor. I am sending through a linearization table. When I send the result to the screen the numbers are changing to fast to read. Is there a way to slow the refresh rate? I tried pitting SB3 in front of the table  and that did not work. Any ideas would be appreciated.

[Time Delay]

I was unable to find an example for a timer.  I am having newbie issues. I enclosed a picture of my try.

 

Thank you in advance.

 

Paul

 

[Thermocouple no reading]

Joe,

 

I figured it would be something simple that would make me hang my head  

 

Thank you Joe,

 

Paul

[Thermocouple no reading]

Thank you in advance.

 

I have a K t/c into the - and + of my V200-18-E3XB snap in. I changed my jumpers as per included sheet.  I hardware configured it to MB1. After download/reset, and going online (glasses) and I look at MB1 it is still 0 value.  I also tried a different t/c to no avail. Do I need anything attached to CM or ACM? it is only a 2 wire t/c.

 

Sorry I am really green to this.

 

[Download canned programs]

Hi all,

Is there a place I am missing that had canned example programs to download and learn from?

Thank in advance,