laporbr
-
Posts
6 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
Downloads
Articles
Media Demo
Posts posted by laporbr
-
-
Hi Vema ,
sorry to say , i have tried so many things i do not remember any more what exactly made it working . So i can not give you any good feedback
hope unitronics will give a feedback
-
Hello ,
i have even used a computer with windows xp where i have full administartive rights on it . I can initialise the enfora modem GSM1308 by using the modem services and then
prepare plc side modem . It's starts running and doesn 't give any error or alarm . ( initialised with the cable deliverd with the modem ) . when i then connect it to the M90 with the standard program cable and the connector MJ10-22)CS72 and try to work with the plc programme
1 first initialise ( set bit SB180 and see if SB181 comes high . this is not happening ???
baudrate is set to 9600
remark : i use the identical software and the same Sim card in a wavecom modem and the it's working .
in attachement the program ( line 40 is initialising the modem and line 41 is send test sms
suggestions ?
What should exactly be in the initialising commands ?
this is what is standard in the field ( adjusted baudrate to 9600 )
i have also tried with hyperterminal but don't find a reason ?
the bit SI 70 is showing value 2
AT&F
WAIT 5
GOBR 115200
AT+CPIN=^XXXX^
WAIT 3
ATS0=1
ATE0
AT&C1
AT&D0
ATX4
ATQ0
ATV1
AT+IPR=9600
WAIT 5
AT+IFC=0,0
AT+CNMI=2,1,0,0,1
AT&W -
sim ok
tested in modem wavecom , worked ok
test in enfora met sim who i know is good , not working
i have trie to initialise the modem by modem services visilogic
seems to work
but
still not working to send sms
status SB180 stays 0 ??
thanks for any further suggestions
-
Hi there
i am trying to initialise the enfora modem PLC side but he keeps on saying modem operation failed modem not initialised . i have done everiting according the manuals ? used the right cable deliverd with the modem .
i am out of possibilitie's what to do ?
What is there to try more ,
thanks for feedback
-
Hi , i have been reading about this error on the forum's but a real soluttion i did not found
i am working with version 9.0
whith vision no problems
with really old program U90 no problems
but with a recently program i get this run time error 5
so according to the forum that are dll 's missing ??? then i should not could save older /other programs .
i have not yet removed and installed unitronics but is /are there other things that i can do ?
many thanks for helping me
Laporbr
Upload controller
in Vision & Samba PLC + HMI Controllers & VisiLogic Software
Posted
I want to verify or upload the program inthe PLC but
the program is protected by a pasword and i don't know the pasword . .
I think i have the original programme but i can also not compare my programme with the program in the plc due to the pasword .
is there a way to do so even without the knowlegde of teh correct pasword ?
thanks for your reply