[Upload controller]

I want to verify or upload the program inthe PLC but

the program is protected by a pasword and i don't know the pasword . .

I think i have the original programme but i can also not compare my programme with the program in the plc due to the pasword .

 

is there a way to do so even without the knowlegde of teh correct pasword ?

 

thanks for your reply

[initialising enfora modem]

Hi Vema ,

sorry to say , i have tried so many things i do not remember any more what exactly made it working . So i can not give you any good feedback

hope unitronics will give a feedback

[initialising enfora modem]

Hello ,

i have even used a computer with windows xp where i have full administartive rights on it . I can initialise the enfora modem GSM1308 by using the modem services and then

prepare plc side modem .  It's starts running and doesn 't give any error or  alarm . ( initialised with the cable deliverd with the modem ) . when i then connect it to the M90 with the standard program cable and the connector MJ10-22)CS72 and try to work with the plc programme

1 first initialise ( set bit SB180 and see if SB181 comes high . this is not happening ???

baudrate is set to 9600

 

remark : i use the identical software and the same Sim card in a wavecom modem and the it's working .

 

in attachement the program ( line 40 is initialising the modem and line 41 is send test sms

 

suggestions ?

What should exactly be in the initialising commands ?

this is what is standard in the field ( adjusted baudrate to 9600 )

i have also tried with hyperterminal but don't find a reason ?

the bit SI 70 is showing value 2

 

 

AT&F
WAIT 5
GOBR 115200
AT+CPIN=^XXXX^
WAIT 3
ATS0=1
ATE0
AT&C1
AT&D0
ATX4
ATQ0
ATV1
AT+IPR=9600
WAIT 5
AT+IFC=0,0
AT+CNMI=2,1,0,0,1
AT&W

[initialising enfora modem]

sim ok

tested in modem wavecom , worked ok

test in enfora met sim who i know is good , not working

i have trie to initialise the modem by modem services visilogic

seems to work

but

still not working to send sms

status SB180 stays 0 ??

 

thanks for any further suggestions

[initialising enfora modem]

Hi there

i am trying to initialise the enfora modem PLC side but he keeps on saying modem operation failed modem not initialised . i have done everiting according the manuals ?  used the right cable deliverd with the modem .

i am out of possibilitie's what to do ?

What is there to try more ,

thanks for feedback

enfora modem .pdf

[Run time error 5]

Hi , i have been reading about this error on the forum's but a real soluttion i did not found

i am working with version 9.0

whith vision no problems

with really old program U90 no problems

but with a recently program i get this run time error 5

so according to the forum that are dll 's missing ??? then i should not could save older /other programs .

i have not yet removed and installed unitronics but is /are there other things that i can do ?

many thanks for helping me

Laporbr