[Overhead Display For Assembly Machine Operators]

I looked at the KEP website. I did not see where your systems would do what I am asking?

[Question about uniDDE]

How many PLC's can you configure in a single uniDDE project? How many operands can be configured in those PLC's?

[Overhead Display For Assembly Machine Operators]

I would like to know what any of you recommend for an overhead display/marque that would emulate Bits and registers from the PLC. The purpose of this would be to give the operators a clear view of their machine performance:

 

Machine Run Time

Machine Down Time 

Good Parts

Bad Parts

Bad Parts %

Machine Efficiency

Machine Utilization

 

Are any of you doing this and if so, what to you recommend to interface with a Unitronics v570?

 

Thanks

 

Karl

[Data Table Copy Rows Not Working]

I know the problem. Sorry but it was a simple one, I wanted to copy to three rows only in my table.

 

My table structure had 3 rows.

 

I set the Data Table - Copy Rows function I set  (Source row number to "0") (Target row number to "1") (Number Of Rows to 3)

 

As I am sure that you know it would not work because the Number of Rows should have been set to "2"

 

Thanks for getting back to me

 

Much appreciated 

 

Karl

 

[Data Table Copy Rows Not Working]

I have given more examples, I am wanting the rows to append. All I am getting is the first row updated. The copy from row 0 to row 1 is not working. I will send the example in three replys

Example 1.docx

[Data Table Copy Rows Not Working]

It will not allow me to attach it because it is 390 KB, I am using the VisiLogic 570 controller. Do you have a suggestion how to get you the program?

[Data Table Copy Rows Not Working]

Here it is, thanks for looking at it

 

Karl

Standard_Diverter_no modbus.vlp

[Data Table Copy Rows Not Working]

I can not get the Table function block (Data Table Copy Rows) to work. It is before the (Data Tables Write Row) Function Block that is working. What I am trying to do is to Copy row 0 to row 1 and then copy the new data into row 0 in the Data table. At one time I had it working and then I built a new Table with less rows and it quit working. Any help would be appreciated.

Example 1.docx