Fredrik denmark
-
Posts
2 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
Downloads
Articles
Media Demo
Posts posted by Fredrik denmark
-
-
Dear network,
I am total new in this... I have a V1210 and EX-D16A3-TO16 + two IO -D16A3 TO16 running with VISILOGIC 9.8.64 build 0
I Have two troubles...
1. When i connect / download Vivilogic comes up with
" Communication could not be stablished due to failure to open port.
Port may be in use by another application or device.
free the port and try again. " Check if this port is used in "modem configuration")
Hmm I dont have anything else connected to my pc...
2. I Need to make some small I/O´s 24 volt sensor signal in - 24 volt signal to AIR valve festo... - very simpel... anyone who know's a youtube link to see how this is done... make this...... ?
Yhank you in advance !
Best Fredrik
Need help For unilogic / Consultat English
in Projects seeking Programmers
Posted
Dear Network,
I started a very small business and build a small filling machine myself - to fill some comestic products - and bought a V1210 and installed visilogic on my pc.
I am almost finish with my installation / machine - and I will shortly mark all my eletric wires in the HW configuration.
Firstly my plan was to start programming myself, but time is less to be familiar with visiologic, so I came to a conclusion - and call for help insted of learning this out.
I need a Consultat contact for programming my PLC via Teamviewer together with me on Whatsapp / Weechat/ Skype - and ofcourse I will pay for hours / work for this job.
Step one is to make the machine run simple.
Step two is to plan - optimize this circles and program optimize.
Eventhougt my cash is low - I hope someone can manage this... I now a lot of peolpe can ...
Help desk from visiologic told me that I should try this out - it´s an easy job/thing and could be done from an other computer - I am not a specialist - but not dump ether ;-)...
The machine is a conveyer - round table - filling pump - signal crimp head - linear electric pick and place - signal labelmachine with a 3 roller ...... there is about 10 optic sensors and 4 pneumatic pistons.
Chinesse, India, are also welcome as long as English is spoken well and you are good working with visilogic / programming PLC ...;-)
Hope someone find this little project fun...
Please contact me on ff@vouvis.com
Best Fredrik Fabian
Denmark