Yeli
-
Posts
3 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Blogs
Downloads
Articles
Media Demo
Posts posted by Yeli
-
-
19 hours ago, kratmel said:
If you hold 5 seconds on the screen at an arbitrary point, you will enter the information mode.
What you get in the second window is the screen calibration window which is one of the info mode modes.
By clicking on the yellow dots, you should complete the screen calibration procedure. If the procedure is completed successfully, you will receive transitions to the information mode. If not, the calibration procedure will continue indefinitely.
If there is a protective film on the screen of your PLC, then most likely a particle of dirt got under it and presses on the screen instead of you. Remove the film and wipe it with a soft cloth.
If the problem persists, you have a problem with the touch screen hardware (glass crack or deep surface damage) or touch screen calibration issue.
Thank you so much. I think there is a problem with my screen because when I touch the yellow dots, another yellow dots appears. It beocmes a loopand I was trapped in for 5 minutes.
I thought it was my problem at first, and I restarted the PLC.However, it jumped to Enter Password Mode from the calibration mode automatically. With the keyboard, I can see that when I want to enter a number, another number is entered. For example, I want to touch the 9 bouton, the 0 bouton is lighted.
Based on this, I think there is a problem with my screen. Do you have any other ideas about this.
Thank you so much
-
Hello
I am using SM70-J-R20 with Visilogic.
I have downloaded my program to the OPLC. The screen displays just like the image below. However, after a few seconds, the screen change into Info Mode. And when I touche the screen at this time, it becomes black with a yellow block, just like the second image. Could you please tell me where might be the problem.
Thank you very much
question about SM70-J-R20 display
in Vision & Samba PLC + HMI Controllers & VisiLogic Software
Posted
Yes, I followed the instruction as kratmel said. I thought there is a problem with my screen.
Thank you so much