Jeferson

Hello Gabriel and Joe thank you for your help. I have looking for more information about the application, then I made a diagram as Gabriel comments that it is possible, with wifi converters, I will send the data from the PLC to the scada system, but this information how it is sent from point A to point B, via TCP/IP or I have to convert to ASCII or bynari. I already set up a tcp/ip communication, in the PLC.

Hi Joe thanks for your help. I did put an Ethernet card in the V1040. For the first step in point A, I don't know how are the necessary parameters, which I have to set in the program for the PLC. I have found an information for visilogic to set up a remote access, but it is not clear. Can you help me with this. I need the serial converter because the V 1040 implementation is 200 meters away from the PC for the scada system. I have attached some pdfs with the information of the components I have, and the link of the visilogic configuration. https://www.i4automation.co.uk/unitronicspdf/VisiLogic - Utilities.pdf rishabh_lm1360_datasheet.pdf rishabh_lm1360_operating_manual.pdf [User-Manual]USR-W630-User-Manual-V1.0.3_1687230152.pdf USR-W630-AT-commands-V1.0.3.pdf

Hello I am a beginner in the application and use of unitronic components : 1. I need to use the vision 1040 as a PLC+HMI controller in a point A, this to register some variables and control some actuators, while the vision 1040 is working I need to send all the information about the variables with the USR-W630, as wifi signal to the point B, in the point B I receive the information and send it to the scada system with the Rish LM-12360. Is it possible to do this application, with these components. I hope someone can help me. Greetings from colombia