[storeing a memory long bit]

I checked again and cannot see anything that could be interfering with this action.

[storeing a memory long bit]

I am trying to do a direct store from ml 1 to ml 2. When i do this it does not put the value from ml 1 to ml 2. does anyone know why?

[large data table]

that is what i meant to say is 10 columns and 9999 rows. Can I make one data table,store it on a sd card and read/write from the sd card?I have tried to build the data table but it says it is to big when i try to save, but i havnt had a screen to try saving it to a sd card.

[large data table]

I have a 1040 screen I need either 9999 data tables are one data table with 10 rows and 9999 colums. what is the easy way of doing this?

[Controlling a DC Fan with a Photohelic]

I need a data table that has 9999 rows. My problem is it takes up to much memory in my 1040 hmi. So if i bought a sd card to put the data table in could i read and write to the sd card or does the hmi load the table from sd card and put in hmi.

[high speed counter]

It will count up/down according to rotating direction, if:

- You connect Shaft encoder - A & B signals to relevant HSC dedicated inputs (for example A & B ).

- You will set in Hardware Configuration of the project HSC to Shadt encoder x 2 or Shaft encoder x 4.

THANKS I HAD THE INPUT SET UP FOR HIGH SPEED COUNTER . WHEN I CHANGED IT TO SHAFT ENCODER X2 IT COUNTED UP AND DOWN. MY ENCODER ONLY HAS A (A SIGNAL) WILL IT BE OK TO USE SHAFT ENCODER X 2 FOR THIS ?

[high speed counter]

my dispay is only counting up. i need it to count up and then count down. i think i may have something set wrong when i set up the high speed counter. any ideas?

[relay outputs will not work]

Did you wire power to the V1 and V2 terminals? See page 4 and 5 of the spec sheet- the relays won't work if you don't.

Joe T.

thanks joe that was the problem.

[relay outputs will not work]

I loaded my project on 1040 hmi with v200-18-e3xb module, all my inputs work but none of my outputs work. i tried just a simple program and still nothing. I can monitor the program and it shows that the output is on but the relay never close. this is all new hardware any one got a clue. i think it is just a bad v200 plug in module.