santosh Posted May 15, 2018 Report Share Posted May 15, 2018 Hello, I am trying to communicate V560 with Rectifier through modbus RS485. PLC pin Details:- Rectifier Pin details:- pcr01 protocol communication Ver 3_23 EN.pdf protocol Support:-Mod bus ASCII fig 1.0 Please Reply Following Points: 1. Is it possible to communicate Unitronics PLC with Rectifier. 2. If Possible how to connect between PLC and Rectifier.(PLC RS485 2 wire and Rectifier rs 485 4 wire ). 3. If I short TX+ to RX+ and TX- , RX- and connect A+ and A- terminal to PLC. is it okay this way? 4. Shall i need to use converter half duplex to full duplex . 5. Rectifier is Supports only MODBUS ASCII. Is it possible to connect as shown in fig 1.0 Please reply with all possible solution. pcr01 protocol communication Ver 3_23 EN.pdf Link to comment Share on other sites More sharing options...
Pradeep Mane Posted May 15, 2018 Report Share Posted May 15, 2018 Santosh, It is possible to communicate as per shown in below set up. You can connect multiple devices as per above set up with terminating last device with 120 ohm resister. do it in this way and let me know. Link to comment Share on other sites More sharing options...
Saimond Schroder Posted Friday at 06:08 PM Report Share Posted Friday at 06:08 PM On 5/15/2018 at 4:41 AM, santosh said: Hello, I am trying to communicate V560 with Rectifier through modbus RS485. PLC pin Details:- Rectifier Pin details:- pcr01 protocol communication Ver 3_23 EN.pdf protocol Support:-Mod bus ASCII fig 1.0 Please Reply Following Points: 1. Is it possible to communicate Unitronics PLC with Rectifier. 2. If Possible how to connect between PLC and Rectifier.(PLC RS485 2 wire and Rectifier rs 485 4 wire ). 3. If I short TX+ to RX+ and TX- , RX- and connect A+ and A- terminal to PLC. is it okay this way? 4. Shall i need to use converter half duplex to full duplex . 5. Rectifier is Supports only MODBUS ASCII. Is it possible to connect as shown in fig 1.0 Please reply with all possible solution. pcr01 protocol communication Ver 3_23 EN.pdf 239.21 kB · 7 downloads Do you still have the file? Can you send it to me? Thanks Link to comment Share on other sites More sharing options...
MVP 2023 Ausman Posted yesterday at 12:33 AM MVP 2023 Report Share Posted yesterday at 12:33 AM The file is still there, but you need to be logged in. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now