How to change baud rate inside the loop program?

[Luiz]

I, trying to change baudrate inside the loop program.

Is it possible, using COM Init Port ?

[Joe Tauser]

Yes, that should work.  Make sure you use a Positive Transitional to call it.

Joe T.

[Luiz]

Thank's for your reply;

Regarding the baudrate change, it's working, but I have a question:

I'm using V120 22 T1 / OS Version 5.04 (28) / Hardware rev A

Is the baudrate 115200 available in this version? The program works, but it's no consistent. The  Scan FB doesn't respond sometimes, and I have to reset controller to restablish communications.

[Ausman]

I don't know full capabilities, but I only ever use 57600 on V120s under serial.  Never had troubles.  Sometimes you need to ensure Device Manager has the same baud rate in it's settings.  This issue seems to be computer specific.

cheers,

Aus

[Joe Tauser]

Don't run a V120 at 115200 - it doesn't work well.

Upgrade to a V130 if you need this baud rate.

Joe T.