Jump to content

Jazz JZ20-R31 Connection problem


Recommended Posts

Hi guys, i have one problem in my plc Jazz JZ20-R31, problems the connected.

I use

1- U90 Ladder V6.6.45
2- Cable MJ20-22-C525
3- Cable Adapter db9 (Serial) to usb
4- have Windows 7 Ultimate x64 bit

The mistake he gives me is

Communications could not be established due to one of the following:

- Cable Connections are not secure
- TimeOut is too short
- Incorret communication settings.

Check your cables and communication settings and try again.


Previously it worked for me but I had some problems and I was forced to change my hard drive, without being able to obtain the information.

I apologize in advance for my English, it's not very good. Thank you!

Link to comment
Share on other sites

6 hours ago, Flex727 said:

Did you confirm in Device Manager that COM 3 is the correct com port? If you had to change hard drives, you may have a different driver for your USB to Serial adapter. Try re-installing that driver.

I attach an image.

I use the same COM3 port and the same cable for another plc using the visiLogic program and it works perfectly.

img.jpg

Link to comment
Share on other sites

19 minutes ago, Joe Tauser said:

The JZ20 series has a built-in USB port that uses the SiLabs CP210x driver.  Did you try plugging a USB mini cable into that port?  It will show up as a different COM port on your device manager.

Joe T.

OMG it worked!!! Thank you. I was all day trying to solve this problem.

Sorry I have another PLC Jazz but JZ10. It does not have that port, it should make a new topic or I can use this topic since the error is the same.

Link to comment
Share on other sites

The  JZ10  Needs the JZ-PRG Programming Kit to communicate and program.   Contact you local distributor if you do not have the kit.

There is a Dongle for the Port  in the JAZZ and a RS232 DB9  connector-  MJ20-22-CS10 -  and a 6 wire cable  in the kit. 

 

DanT

 

Link to comment
Share on other sites

7 hours ago, DanT said:

The  JZ10  Needs the JZ-PRG Programming Kit to communicate and program.   Contact you local distributor if you do not have the kit.

There is a Dongle for the Port  in the JAZZ and a RS232 DB9  connector-  MJ20-22-CS10 -  and a 6 wire cable  in the kit. 

 

DanT

 

before the hard drive was damaged, I used an MJ20-22-CS25 cable and its usb converter together with the u90 ladder version 6.4.0 on my previous hard drive and it worked correctly.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

This site uses cookies. By clicking I accept, you agree to their use.