wassim Posted October 25, 2016 Report Share Posted October 25, 2016 Hello Guys, I am facing Problem to connect a V280 to my laptop, we check all the setings, we even change the usb to serial cable, we change the also the device with an other v280, we still unable to connect the the OS version on the PLC is V5.04 (B13) on the Laptop we have Visilogic version 9.8.31, when we try to connect it shows the following Any one who can assist or knows what could be the problem? Link to comment Share on other sites More sharing options...
MVP 2023 Flex727 Posted October 26, 2016 MVP 2023 Report Share Posted October 26, 2016 Confirm you have selected the correct Com port in the VisiLogic software. If that's correct, and you are using the Unitronics cable, then the most likely problem is a driver issue. Link to comment Share on other sites More sharing options...
MVP 2023 Ausman Posted October 27, 2016 MVP 2023 Report Share Posted October 27, 2016 Hi Wassim, I see no image in your post after "shows the following", so I can only add to what Flex has said, and that is to make sure that you have matching baud rates in device manager and Visilogic, normally 57600. I have had instances of no connection when the setting in device manager is not the same. Other than that, perhaps have a good read of all the ideas in this other post, to follow up what Flex has said about drivers: cheers, Aus Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now