Vision & Samba PLC + HMI Controllers & VisiLogic Software

Ebenezer, your post implies that you think that 1111 does work ok.  However, H1111 is NOT 1111, it is 4369.  This goes further to pointing to needing 4 different numbers.  Do you need to use MB4002, or does the SB2 bit do the job?  

I had the same problem on my V700, I used the ladder above and it worked

It's been a while so here's a few to make you gag, or use on your kids..... My friend David has lost his ID.  Now we just call him Dav. I've been reading a book about anti-gravity.  I could just not put it down. My wife's birthday is coming up and she's been dropping hints by leaving jewellery magazines around the house.  So I bought her a magazine rack. What happens if a duck falls into a concrete mixer?  You get quacks in the concrete. I got pulled over by the cops this morning, and they asked me lots of questions and if I had a police record.  I said no, but I do have a Sting CD. I think I'd better stop now.  But wait, there's a long one....maybe tomorrowwwwww. cheers, Aus

Did you run the install correctly as right click admin?

Hi George Very good point. I also had forgotten about the limited space of the Samba, Regards Denis