Projects seeking Programmers
If you are in need of a paid programmer to write your Unitronics’ project, post here to look for someone in your area.
**Disclaimer: Unitronics bears no responsibility. This is just a place for people to find each other**
42 topics in this forum
-
- 7 replies
- 2.3k views
-
- 2 replies
- 1.4k views
-
- 1 reply
- 1.4k views
-
- 1 reply
- 1.4k views
-
- 1 reply
- 1.6k views
-
- 1 reply
- 1.5k views
-
- 3 replies
- 2.2k views
-
- 0 replies
- 2.3k views
-
- 0 replies
- 1.5k views
-
- Guest
-
- 1 reply
- 1.6k views
-
- 0 replies
- 2.3k views
-
- 3 replies
- 2k views
-
- 0 replies
- 1.6k views
-
- 0 replies
- 1.6k views
-
- 5 replies
- 4.5k views
-
- 3 replies
- 2.3k views
-
- 3 replies
- 2.7k views
-
Member Statistics
9,348
Total Members1,206
Most Online
-
Topics
-
-
Who's Online (See full list)
-
Posts
-
Hi Saragani, Thank you once again for your help, much appreciated. I have implemented your suggestions, and the system is now much more stable. I have a question regarding the PLC connection status. Currently, I’m using the property plc.PLCChannel.Connected to check if the PLC is connected. However, I’ve noticed that it sometimes switches from true to false. Is this a reliable method for determining the PLC connection status? If not, is there a better way to accurately check if the PLC is connected? If it is reliable, what actions should I take when it returns false? Should I attempt to reconnect, reinitialize, or handle it in some other way? How do I do it? Thanks. -
I mean that the PLC did not complete the previous Action file. And you need to give it a USB, not an update firmware, but an Action file with some minor function like Read All settings (TOOLS=>USB Action file Creator). In addition, try to get to PLC through the VNC and look in the Uni Apps what is wrong. If the address 192.168.1.4 is pinged, then it is probably access to the VNC. -
I've done this many times. With nothing connected except power, it boots up with a red blinking ERROR light immediately when the RUN light turns green. -
I always found that upgrading with SD card to be more reliable than USB -
Red blink, Green ON= USB Action ran with error – disconnect the USB drive to dismiss the error. https://i4automation.co.uk/wp-content/uploads/2023/06/Unistream-USC-Series-USB-Actions.pdf
-
-
Blog Entries
-
