Jazz, M91 PLCs and U90Ladder
Talk about issues related to Jazz, M91 PLCs, and the U90Ladder software
492 topics in this forum
-
- 15 replies
- 5.1k views
-
- 0 replies
- 3.2k views
-
- 2 replies
- 329 views
-
- 6 replies
- 1.2k views
-
- 1 reply
- 184 views
-
- 2 replies
- 101 views
-
- 3 replies
- 356 views
-
- 3 replies
- 201 views
-
- 3 replies
- 300 views
-
- 7 replies
- 472 views
-
- 16 replies
- 613 views
-
- 2 replies
- 321 views
-
- 2 replies
- 212 views
-
- 5 replies
- 310 views
-
- 5 replies
- 4.6k views
-
- 3 replies
- 475 views
-
- 2 replies
- 287 views
-
- 1 reply
- 303 views
-
- 2 replies
- 290 views
-
- 11 replies
- 3.4k views
-
- 5 replies
- 368 views
-
- 1 reply
- 421 views
-
- 1 reply
- 610 views
-
- 2 replies
- 252 views
-
- 26 replies
- 3.7k views
-
Member Statistics
8,533
Total Members1,206
Most Online
-
Topics
-
-
Who's Online (See full list)
-
Posts
-
-
Thanks for your reply! Correct, it is a UniStream program. Thanks for explaining - I understand better now. Using a bit for each run and then OR'ing them works well. Peter -
By Joe Tauser · Posted
It looks like this is a UniStream program. True? You can only use a regular coil once in a program. In ladder logic all rungs are scanned and solved and the last one wins. In your program example above use different bits for each rung, and then OR them all together below your logic for the actual controlled bit. Joe T. -
I am a very new user of ladder logic and having some problems understanding where I am going wrong. I am writing a simple program to turn on and off some digital outputs (aliased as PV09, PV10, SV02 in my logic) in a series of steps with a set delay during each step. The coils turn on in the expected way, however when the inputs to the output coil turns off then the output remains high in the code and in the actual digital output. I paste a snippet of my logic in online mode below - each rung is supposed to be a single step (Step[1] and Step[2]) which should finish once the bit for the next step is set, however the outputs (PV09/PV10/SV02) remain high even though the input into them is low. These outputs are not referenced anywhere else in the code so I can't understand why they are high. Thanks for any help in advance!
-
Yeah...my bad, it's a subroutine call in the main program😅I caught the error. This subroutine is only called with a condition that is not met, I didn't realize. Thanks for opening my eyes.
-
-
Blog Entries
-
