UniLogic Software
Receive and share information about UniLogic, the application software for the UniStream control platform
1,496 topics in this forum
-
- 0 replies
- 430 views
-
- 4 replies
- 1.6k views
-
- 1 reply
- 562 views
-
- 11 replies
- 365 views
-
- 9 replies
- 1.6k views
-
- 6 replies
- 2.2k views
-
- 0 replies
- 343 views
-
- 1 reply
- 418 views
-
- 2 replies
- 874 views
-
- 5 replies
- 924 views
-
- 3 replies
- 445 views
-
- 4 replies
- 1.2k views
-
- 1 reply
- 829 views
-
- 13 replies
- 1.6k views
-
- 3 replies
- 425 views
-
- 4 replies
- 438 views
-
- 21 replies
- 1.3k views
-
- 1 reply
- 507 views
-
- 10 replies
- 5.2k views
-
- 4 replies
- 1.3k views
-
- 0 replies
- 492 views
-
- 1 reply
- 280 views
-
- 6 replies
- 809 views
-
- 2 replies
- 422 views
-
- 2 replies
- 524 views
-
Member Statistics
8,527
Total Members1,206
Most Online
-
Topics
-
-
Who's Online (See full list)
-
Posts
-
Thanks for sharing this. I was able to repair the corrupted image file and re-image the SD Card using Rufus and it worked. -
Omron? Maybe, but I think not. I'm assuming this is meant to be in the Vision forum, so I've moved it. I only use V130s but I'm guessing it will be similar...... to turn the screen backlight off you use SI9. I default it to 0, and use SB6 into a TE to store 100 into it so that it remains fully on during use, then goes completely off on timeout by a store back to 0. Others will no doubt do a different method....that's part of PLC programmings nature! cheers, Aus -
However, based on the information available, it seems that you might be referring to an Omron V430-F Series Autofocus Multicode Reader. If that’s the case, you can set or change the length of time the signals assigned to Outputs 1 to 3 are in an ON state and the timing of when they turn OFF through the device’s settings -
Last week, I had a seriously problem.... I couldn't start the unilogic software (version 1.33.36) anymore. Every time, after showing the splash screen, I had an error and unilogic was shutting down. I made an urgent request to the support divison of Unitronic what could be the problem.... They took over my laptop to see what the problem could be (I don't see any other supplier of PLC's doing this) they found the problem -> in my regional settings, the list separator was a space -> just had to change this in comma and problem was fixed A great "THANK YOU" for the software department of Unitronics !!!!! of course, this is a bug and they are trying to solve this permanently (in a newer version or with a patch or workaround) -
Nothing complicated about it. UniLogic allows as many different versions installed simultaneously as you wish. Just select the correct shortcut when starting up the software. VisiLogic has one extra step (running Version Swapper), but still you don't need anything like separate "virtual machines".
-
-
Blog Entries
-
